Dual Outlet Power Supply – Custom version

(1 customer review)

$595.00

The Dual-Outlet power supply can be used to replace two small AC plug-in power adaptors that comes with many audio equipment, routers, NAS etc, and provides significant improvement in sound quality.

The design is based on the experience gained with the TeddyCap family of power supplies for Naim Audio equipment, and uses the same technology.

Enter the required voltage for outlet1
 
Enter the required voltage for outlet2 (up to 12V difference from Outlet1)
  • Total: $0.00
- +
Add to wishlist
SKU: 1133 Category:

Description

Details

 The Dual-Outlet power supply can be used to replace two small AC plug-in power adaptors that comes with many audio equipment, routers, NAS etc, and provides significant improvement in sound quality.

The design is based on the experience gained with the TeddyCap family of power supplies for Naim Audio equipment, and uses the same technology.

Sound

In general, you’ll experience more clarity, tighter bass, more detail, better dynamics, natural voices, better soundstage etc.

Performance

The small power supply which is provided with most types of equipment is based on a technology called Switch Mode. Using this technology it is possible to create small, efficient, and low cost power supplies. Unfortunately due to their method of operation (high frequency capacitor charging), these power supplies are also very noisy, causing degradation in sound quality. As an alternative, several after market power supplies exist which are usually based on Linear Regulators. These regulators provides an improvement over the original power supply but as can be seen on the graph below are still limited in their performance.

The Dual power supply is based on a superior regulator called SuperTeddyReg and provides a significant improvement over linear regulators.

The following graph shows the noise level measurements of the original wall wart power supply (red line), an alternative power supply based on a Liner Regulator (blue line), and the Dual12 power supply (black line). The brown line is a zero Volt reference which is actually the measurement equipment internal noise. As can be seen the Dual12 power supply noise level is very close to the zero Volt reference.

For more information about our power supplies read here…

Interconnects

The Dual-Outlet power supply is equipped with two high quality cables made of silver plated PTFE insulated wires. The cable capacitance is around 13pF/ft, and its resistance is also very low, around 10 milliohm/ft.

Additional information

Weight 2.2 kg
Dimensions 24 × 16 × 6 cm

1 review for Dual Outlet Power Supply – Custom version

  1. Robert Davies (verified owner)

    Here is the challenge: I have a Rega P7 which come with a TT PSU ( 24v AC) powered by a classic wall wart that gets very hot. After upgrading from a MM to MC cartridge I have two Graham Slee phono amps (Reflex M and Elevator, each with external power supplies (2 x 24v DC) – there are wires everywhere! At best that seems to be two TP power supplies, but after a brief chat with Yair he suggested a “triple” – 2 x 24v DC and I x 24v AC in one custom unit. Brilliant! Needless to say it sounds fantastic. Actually, if I had known about the TP phono amp I would probably have got that at the beginning!

Add a review